Nodopedia

Tilt Nodon

I'll let everybody know if the Nintendo Switch console or Joy-Con is being tilted!

Port

Input

Port name	Port function	Input operation
Y reset	When a value other than 0.00 is received at this port, the y-axis angle will reset to a standard value. The standard value will be remembered independently by each Nodon.	Determines whether a signal is or is not equal to 0.00

Port name	Port function	Output value
Tilt angle	Information about the change in tilt from the console or Joy-Con will be collected as tilt data and then converted according to the Output and Range settings, or be output as an angle.	Tilt mode: Between -1.00 and 1.00 (The default Output Range is between -0.50 and 0.50) Angle of Rotation mode: Between -180.00 and 180.00 Measured in degrees (°).

None

Determines which controller will be checked.

Setting value	Description
Auto	Automatically switches the target to be checked, depending on which controller is connected. See also: Automatic Switching between Controllers
 Joy‑Con (L) Joy‑Con (R)	Checks the specified target.

Select which controller to check.

This setting is only available when Check What? is set to Joy-Con.

Sets how the raw input will be converted before being sent as output.

Only effective in Tilt mode.

Setting value	Description
Digital	Outputs either 1.00 if the value is within the specified range or 0.00 if it's outside the range. It's judged to be within range if it's equal or less than the upper value of the range and equal or more than the lower value.
Analog	Passes on any input that falls within the specified range, converted to a value between 0.00 and 1.00 (as opposed to either 0.00 or 1.00).

Sets the axis that the Nodon checks.

Sets how to interpret tilt data from the controller and how to output it.

Setting value	Description
Tilt	Converts the tilt data from the console or the Joy-Con and outputs it according to the Output and Range settings. Tilting left or down creates a negative value, and tilting right or up creates a positive value.
Angle of rotation	Outputs the tilt data of the console or the Joy-Con as an angle. The output is measured in degrees (°). Note: For the z-axis, the number is the reverse of that in tilt mode.

Go back home